L200 Radios

[James1979]

It’s late and I’ve not really looked properly so it’s probably me being thick, but….

How the hell does the radio in the 2012 4work come out please?!

It’s the kenwood which I believe is factory fitted?

I can’t get the removal tool down the side and it looks like it’s screwed in? Quick look from under dash doesn’t seem to show any screw heads

I will look properly tomorrow but wondered if anyone else had been there?

As an aside, what’s happened to l200.org? It’s sort of mothballed?

 

[Bornfree]

Engine out, cut hole in bulkhead. Easy

 

[James1979]

That may be the way forward!!

Either that or slide hammer in CD slot…..

 

[Craig-SM]

If it's like the Shogun you remove the facia around it which is just held by clips and that gives you access to the screws holding the radio in

 

[Craig-SM]

 

[James1979]

If it's like the Shogun you remove the facia around it which is just held by clips and that gives you access to the screws holding the radio in

That sounds like a plan

Thanks for the video. It’s the same as all the ones I’ve found so far. The 4work doesn’t have that there. It’s just a normal DIN slot below the blower controls. The place where that screen goes on mine is a (much handier!) storage bin

 

[Kayos]

Mine had a single din below the heater and a trip computer above. Std removal tool for the radio, relocated the computer to the radio slot and fitted an android double din

 

[James1979]

Finally got back to this earlier.

You have to pull the plastic panel out - just held on with clips, then unscrew the radio in its carrier from the car.

Might help someone

Thanks for all the input though.