Looking to replace 2 small lengths pictured, ones about 15cm long the other about 45cm.
Don't know what the threaded end joints are yet to fit junction boxes, OD of the Kopex itself is 20mm best I can measure.
Rubbed down one end and the threaded unions look braised on.
Whats my best route to replace - ideally brass ends as OE and galv Kopex.
Is there an outfit that makes them up?
Don't know what the threaded end joints are yet to fit junction boxes, OD of the Kopex itself is 20mm best I can measure.
Rubbed down one end and the threaded unions look braised on.
Whats my best route to replace - ideally brass ends as OE and galv Kopex.
Is there an outfit that makes them up?