I bought gas and regulator for my 130EN at the weekend.
What a difference! I now think that thin sheet will be possible.
I am using 0.6mm wire with C02 gas. The first thing I noticed was that I wasn't getting the penetration so I turned the power up. Is this normal? Is it just because the wire is thinner?
How do I adjust the gas flow? The instructions I've read say turn it up until there is a noticeable hiss (without poking the wire through my eardrum). What are the indications in weld quality that I should look for?
thanks
What a difference! I now think that thin sheet will be possible.
I am using 0.6mm wire with C02 gas. The first thing I noticed was that I wasn't getting the penetration so I turned the power up. Is this normal? Is it just because the wire is thinner?
How do I adjust the gas flow? The instructions I've read say turn it up until there is a noticeable hiss (without poking the wire through my eardrum). What are the indications in weld quality that I should look for?
thanks