Jacking beam

[reb78]

I have a 3.5 tonne 1977 Bradbury Dockmaster 4 post lift with wheels free beams. I'd really like a jacking beam as well bit have always been unsure if I can fit one to it.

Can anyone who knows these lifts help point me in the right direction for what I need?

Serial number is 773-1219 if that helps at all?

 

[sako243]

I just had to relocate my lift that's still to be put up to get it out of the way of 350t of stone that's going down soonish. I haven't put a tarp over it so I'll try and get a photo of the relevant bits tomorrow for you Rich.

 

[Melvyn Best]

I removed the wheels free bars from a Bradbury and replaced them with a jacking beam, so much easier to do most jobs on !

 

[mm289]

I've got a couple on my Bradbury, both made by "majorlift" You can just about make them out in this post https://www.mig-welding.co.uk/forum...-4-post-lift-manual.87481/page-3#post-1863146

The "ears" are adjustable to fit different width ramps

The yellow one runs on bearings which makes it much easier to move,

PS if you buy second hand make sure it has the lift blocks/pads as these often are missing IMHO

Cheers

MM