chuk
Member
- Messages
- 56
Hey guys, ive been watching this forum and contributing a little latley. anyways i about done collecting parts and making templates for the axle swap on my suzuki and im ready to start fabing some crutial parts. Is my welder up to it, ive tried out the calculator and it says it will weld 5mm. Im using 5mm plate for most of the mounts and other parts but should i settle for that? the welder claims it will weld 6mm.
Its did the job for the last project which was most 4mm stuff but i think its time to move on Id like go gas so i can see more clearly and get sweet looking welds.
by the way its a cosmo 170 gas/gasless.
What would you recomend buying instead, id like a welder with decent gas setup but not stupid prices.
thanks chuk
Its did the job for the last project which was most 4mm stuff but i think its time to move on Id like go gas so i can see more clearly and get sweet looking welds.
by the way its a cosmo 170 gas/gasless.
What would you recomend buying instead, id like a welder with decent gas setup but not stupid prices.
thanks chuk