Johnny™
Whistle! Squawk! Tweet!
- Messages
- 112
Has anyone bought and tried to use these intergrips on thin body work as they are intended?
they leave a 1mm gap between sheets which i have found is just too big. even at 20 amps the lowest setting on my portamig, im finding to get spread im just melting the edges? and one else found this?
im using CO2 and 0.6 wire. Butting the edges tight together i have no problems.
So im finding it was a wasted purchase
they leave a 1mm gap between sheets which i have found is just too big. even at 20 amps the lowest setting on my portamig, im finding to get spread im just melting the edges? and one else found this?
im using CO2 and 0.6 wire. Butting the edges tight together i have no problems.
So im finding it was a wasted purchase