- Messages
- 14,358
- Location
- UK
Anyone know what the general allowance is for an 'interference fit' between two components?
The job is a flywheel pressed onto a shaft. its a refurb job, built up a worn out shaft and the bore of the flywheel where it has spun on the shaft and eaten it away. Shaft is (was) 128.4mm dia.
I wanted to just weld it on, but they won't let me
Need to know what to allow before getting it machined back to size.
Ta
The job is a flywheel pressed onto a shaft. its a refurb job, built up a worn out shaft and the bore of the flywheel where it has spun on the shaft and eaten it away. Shaft is (was) 128.4mm dia.
I wanted to just weld it on, but they won't let me
Need to know what to allow before getting it machined back to size.
Ta