rosinante
Member
- Messages
- 1,307
- Location
- Cornwall England
Morning chaps ,
Our move is progressing , the new to us home has a garage roof that is corrugated steel plastic coated , it sits on 6x2 joists there is a layer of what looks like a breathable membrane between the two , how would it be best to insulate it , if Ì use celotex or similar should I leave an air gap above it ? Then board joists ? Ideally I would like to line the walls as well , hopefully turning it into a woodworking shop at the back end, the front end is staying as a vehicle area , its 36 ft long, separated by an up and over, the front end was formally a car port that has been enclosed via an up and over door at the front .Any advice or caveats welcome,
Cheers
Our move is progressing , the new to us home has a garage roof that is corrugated steel plastic coated , it sits on 6x2 joists there is a layer of what looks like a breathable membrane between the two , how would it be best to insulate it , if Ì use celotex or similar should I leave an air gap above it ? Then board joists ? Ideally I would like to line the walls as well , hopefully turning it into a woodworking shop at the back end, the front end is staying as a vehicle area , its 36 ft long, separated by an up and over, the front end was formally a car port that has been enclosed via an up and over door at the front .Any advice or caveats welcome,
Cheers