instructions on changing liner on SIP migmate 130

[locoboy]

Guys,

I bought a new linet etc from weldequip and i remember seeing a step by step guide inc photos (i think) on here of how to change the liner.

Im buggers if i can find it now though - anyone shed any light?

Thanks in advance.

 

[malcolm]

Here is it - http://www.mig-welding.co.uk/sip-wirefeed.htm

 

[locoboy]

Ahhh good man, thanks -off to the garage i go then.

 

[locoboy]

Arrrrrrrrgh!

A 10 minute job has just turned into an hour and a quarter!

got the new liner in no problem, cut tolenght all spot on then when i was screwing the gas feed quick release connector back into the brass block i overtightened it (although it was not all the way home) and snapped it off in the brass block - feck ******** and pish i proclaimed

Then i got my ectractors out and tried to recover the bit from in the threaded hole and snapped my extractor off in there too so its well and truely up the swany.

I was looking forward to just getting it hooked up to the gas and laying a couple of minimum amp welds and seeing what the difference was like.

Well ****** off

Im off for a pint of Cockerhoop

Catch up with you tomorro....................

 

[Wozzaaah]

I shouldn't laugh at your misfortune but your post did make me chuckle
Weldequip might have a gas valve to fit your torch, send him a PM.