Hi i have a INE 245 mig and its just two years old and is well looked after but this year it started to stop feeding out the wire and i would leave it for a few days and start the welder up again and it will work ok but now it has stop feeding wire completely eveything esle works fine it just wont push the wire can anyone help i was told these were good welders and it has realy not done a lot of work its still like new please can anyone help.mac..
- Thread starter INE245
- Start date
- Messages
- 23,018
- Location
- Birmingham
Welcome 
to the forum.
When you say it won't push wire, do the feed rolls go round without the tension arm on?
to the forum.When you say it won't push wire, do the feed rolls go round without the tension arm on?
- Messages
- 23,018
- Location
- Birmingham
Next thing is to test the feed motor by unplugging/disconnecting from PCB or connector and connecting it to a car battery
madkayaker
Pro sparkey Pro Welder
- Messages
- 13,678
with a car bulb in series to help keep the smoke in the motor
