Lawnmowerboy
Member
- Messages
- 2,165
Hi all. Indicators have Decided to cease functioning on my little 205. Hazards work fine and relay seems ok. Any ideas I'm a bit stuck as to where to look.
Cheers will.
Cheers will.
- Thread starter Lawnmowerboy
- Start date
AndyStobbs
Member
- Messages
- 2,475
- Location
- North West England
Hard to speculate without seeing a wiring diagram - don't have any intimate knowledge of the 205. If nobody can offer up any suggestions I will dig out a diagram tomorrow and have a scan.
Could be separate flashers for hazards and indicators, a problems with the stalk, etc...
Could be separate flashers for hazards and indicators, a problems with the stalk, etc...
Lawnmowerboy
Member
- Messages
- 2,165
Forgot to say swapped over the stalk already cleaned some earth's. A wiring diagram would be handy. There is absolutely nothing happening when you move the stalk. I'm pretty sure it's all on the same relay as it is marked 92w/46w which I assume the high of the 2 is for the hazards? I will try a new relay as have one from my spare car. I dunno if there is something I am missing?
doubleboost
Member
- Messages
- 3,865
- Location
- Newcastle upon Tyne England
Hazard switches give problems
AndyStobbs
Member
- Messages
- 2,475
- Location
- North West England
Wouldn't that mean they flash constantly though?
Lawnmowerboy
Member
- Messages
- 2,165
The hazards a fine it's just the indicators. They have been working.
the snooper
getting older by the day
- Messages
- 21,078
- Location
- Hull UK
Could still be the hazard switch I assume both hazards use the same flash relay and as you have replaced the stalk try some
switch cleaner on hazard switch
mfletch
Member
- Messages
- 431
- Location
- Mansfield
there's a switch over in the hazards switch from hazards to normal indicators so if someone used the hazards and then turns them off the switch back to normal indicators sometimes sticks it don't contact
- Messages
- 23,222
- Location
- Birmingham
Had that happen with a Land Rover, took hours to find the fault - replaced hazard switch to cure.
doubleboost
Member
- Messages
- 3,865
- Location
- Newcastle upon Tyne England
The switch has a good chance of being at fault
Not much left after that
Not much left after that
madkayaker
Pro sparkey Pro Welder
- Messages
- 13,678
Mine occasionally players up.
normspanners
Member
- Messages
- 8,853
hazard switch for me too.
Lawnmowerboy
Member
- Messages
- 2,165
Ah! Brilliant will have a crack later and report back!!
gerrymoore
CNC expert (well, getting there!)
- Messages
- 1,271
- Location
- Wirral UK
Not sure if the 205 has any of the 'computer contro'l that my 307 has? My indicators suddenly stopped working last year while I was on the motorway. Got home and tried allsorts..still nothing. Went on a 307 forum and someone had posted a method of resetting the computer...can't remember exactly but it involved opening the window, getting out and closing the door and then a mix of leaning in and switching the ignition on and off while doing various other things with the indicator switches...it worked and all the indicators have been fine since...worth trying a post on the 205 forum??
Lawnmowerboy
Member
- Messages
- 2,165
Nooo! Not an ecu or computer in sight. Mother has a 207 hdi and isn't a bad motor to be honest . But switch sounds like the likely suspect.
