I need a small bushing made.

[sardine]

Just a basic part with no exact tolerances. I have a drawing of it in detail but it's basically 1.5 " diameter bar x 1.5" long , and a 20 mm bore. Mild steel.

Would have to be posted.

Anyone interested ?

 

[Seadog]

I could do it for you. Does it need a reamed bore?

 

[grim_d]

Got to love a good mix of units

 

[500e]

Just showing our age i cant visualise anything over 400mm in metric

 

[brightspark]

it might be imperial bar and wanting metric hole through it

 

[sardine]

1. Mild or any weldable carbon steel.
2. No surface finish required , part won't be visible.
3. No holes are reamed.
4. Bore is to press fit or weld in place 20 mm steel conduit ( .780" OD +/- 0.005" )

 

[brightspark]

a bit more than just a steel bar with a hole in then as 1st described

 

[sardine]

The tube end just has to get in the bore by any means, tacked on if its loose fit or reduced on a belt sander until it can be smashed on.

 

[brightspark]

conduit isn't properly round anyhow its rolled and welded