Williamraff
New Member
- Messages
- 9
- Location
- Uk Leeds
Hi folks,
I am at a loss - I have tried everything I know to make my Clarke 151te work?
It burns back to the tip “every” time I try to use it!
I bought the machine ten years ago and it seemed to work ok but now - it just goes bang and burns back to the tip?
I have set the machine as Clarke recommend and I am using disposable Argon Co2 mix.
I have cleaned the tip and shroud and the wire feeds through fine - the wire is old but looks like new - stored inside!
Metal is clean, Earth connection is good.
I can’t get a bad weld - I can’t get any type of weld?
Any assistance on the above would be greatly appreciated!
Many thanks, Will.
I am at a loss - I have tried everything I know to make my Clarke 151te work?
It burns back to the tip “every” time I try to use it!
I bought the machine ten years ago and it seemed to work ok but now - it just goes bang and burns back to the tip?
I have set the machine as Clarke recommend and I am using disposable Argon Co2 mix.
I have cleaned the tip and shroud and the wire feeds through fine - the wire is old but looks like new - stored inside!
Metal is clean, Earth connection is good.
I can’t get a bad weld - I can’t get any type of weld?
Any assistance on the above would be greatly appreciated!
Many thanks, Will.