Hypertherm not working

[eddie49]

The Oxford has two output voltages , 50 V and 80 V , with up to 180 A available on either.

The 80v would probably be fine, but I'm fairly sure you would need to rectify that AC output to make it into a plasma cutter.

 

[oldbikedavey]

The 80v would probably be fine, but I'm fairly sure you would need to rectify that AC output to make it into a plasma cutter.

Rectifier is present, correct, and functioning well.....

 

[Farm789]

Used it a fair bit now and still on the same tip and there doesn’t seem to be any sort of damage to the tip yet , unlike the old powermax 30, which would of got through a few swirl rings and nozzles if I was using that