I have an Eastwood 110 volt MIG welder model 125. I have been practicing with 1/8" steel using Argon/Co2. I never welded before. I need to weld some re-inforcement plates on my car chassis.
1973 Triumph TR6 (This link documents the job):
http://tr6.danielsonfamily.org/DiffMounts.htm
Here are my latest practice welds:
Does this look like its good penetration?
Any tips would be greatly appreciated!
1973 Triumph TR6 (This link documents the job):
http://tr6.danielsonfamily.org/DiffMounts.htm
Here are my latest practice welds:

Does this look like its good penetration?

Any tips would be greatly appreciated!