honda gx160 clone engine

[Am333rcr]

so my hydraulic powerpacks engines dead.

output shaft on honda 3/4 or 19mm rougly.
the clone engines to replace these have out pit shaft of 20mm.

poeple seem to say they work well. should i be concerned or am i worrying to much. thoughts

 

[8ob]

Loncin supply them with 3/4" shafts, I have used them as Honda replacements for years.

Loncin G200F-P 6.5Hp Stationary Engine for Go Kart Replaces Honda Gx200 for sale online | eBay UK

Find many great new & used options and get the best deals for Loncin G200F-P 6.5Hp Stationary Engine for Go Kart Replaces Honda Gx200 at the best online prices at eBay UK! Free delivery for many products!

www.ebay.co.uk

Bob

 

[James1979]

Think there was a thread about this before. @winchman - was it you? Apologies if not

 

[Am333rcr]

ah

i was looking at cheapoos . will be going for one of those.i think

 

[winchman]

Think there was a thread about this before. @winchman - was it you? Apologies if not

It was me
As mentioned above the shafts are mostly 20mm I have to turn down the crankshaft end on mine as the clutch is 19mm / 3/4 common issue.

 

[frank horton]

I have a few machines with these copy engines.....some are more than 10 years old ....still start easily and work well......
have also used these engines new to repair stuff.....cheap but good.........

 

[pedrobedro]

My splitter has a Loncin 6.5hp engine and it's a good starter and economical on fuel.