HiCon / Ethernet issues Swifty

[Brad93]

Cannot connect PC to swift cut Swifty table.

I'm receiving packets but can't seem to send any.

Unsure if PC or the Hicon board.

Anyone have any experience? i don't have another pc to test with.

 

[MoreWellie]

The "different network" means that the device you are pinging from and the ping target device have IP addresses that tells it they are not on the same network
A ping can still work but there has to be a route from one network to the other so the packets know where to go through to get there

it looks like HICON is on 192.168.0.35. Do you know what the IP address on your PC is?

Go into Details on that Ethernet Status page and it should tell you

 

[tommullin]

firewall?

 

[MoreWellie]

firewall?

doubtful, if it was this the ping would just show up as no response with all packets being lost

 

[tigdlo]

What message does this screen show when the ethernet is disconnected?

 

[MetalMonkey]

Does it have wifi? I'm wondering if you have it connected via WiFi for Internet and Ethernet for the plasma?

Do an

IPCONFIG /ALL

And post the full result - it will provide a bit of insight as to how the networking is connected.

 

[Brad93]

i've managed to get it working by manually setting the computers IP address to 192.168.0.10