I managed to disturb a brake pipe while replacing my outrigger and I'm looking for some advice on what flare to use for a connector. Pretty gutted as I need the car tomorrow and I was tight for time anyway but I barely moved the pipe so better it happened on the drive than while I was driving.
This is the tool I have, I've only used it for male and female fittings before:
and this is the connector:
Forgive the poor drawing but this is what it's like inside:
The pipe is 3/16th and the fixings 10mm. I've had a look online and confused a little by seeing a DIN flare suggested for this type of fitting but I don't think my tool does this. The manual mentions it but only for other size brake pipes and it's not very clear how to do it. This is what I was planning on using does anyone know if this will fit ok:
Any help much appreciated
This is the tool I have, I've only used it for male and female fittings before:
and this is the connector:
Forgive the poor drawing but this is what it's like inside:
The pipe is 3/16th and the fixings 10mm. I've had a look online and confused a little by seeing a DIN flare suggested for this type of fitting but I don't think my tool does this. The manual mentions it but only for other size brake pipes and it's not very clear how to do it. This is what I was planning on using does anyone know if this will fit ok:
Any help much appreciated