Hi...
Well struggling with a BOC 200c Mig welder, I think it's is made by Kemppi
A few Issues and BOC can not provide the handbook, the wire feed is one, the drive is with toothed rollers, there are two grooves one for 0.6 and the other for 0.8 but I can not et the groove to line up and I think this is the root cause of my frustration with the wire feed....
Can any one throw some light on things please...
Thanks in advance .... rhe welder is circa 4 years old and I have never been 100% with it, essentially a good machine let down by my knowledge..
Well struggling with a BOC 200c Mig welder, I think it's is made by Kemppi
A few Issues and BOC can not provide the handbook, the wire feed is one, the drive is with toothed rollers, there are two grooves one for 0.6 and the other for 0.8 but I can not et the groove to line up and I think this is the root cause of my frustration with the wire feed....
Can any one throw some light on things please...
Thanks in advance .... rhe welder is circa 4 years old and I have never been 100% with it, essentially a good machine let down by my knowledge..