Hey all,
I went to a local welding store but I don't think they have done me any favors.
They gave me a flow meter but it only seems to connect if it's positioned horizontally and I assume this wont work properly unless its vertical.
The male connection on the regulator was the connection to the welder gas line. Do I get some form of reducer to connect these two or do I try get a different female to male connection that reduces down?
The flow regulator horizontal connection to where it would connect to the welder gas line is also too large as you can see from the connection on the regulator. Should I get a reducer for this or should I try get a single male - male connection to fit here?
OR really is this just too much effort and should I look for a different solution?
I went to a local welding store but I don't think they have done me any favors.
They gave me a flow meter but it only seems to connect if it's positioned horizontally and I assume this wont work properly unless its vertical.
The male connection on the regulator was the connection to the welder gas line. Do I get some form of reducer to connect these two or do I try get a different female to male connection that reduces down?
The flow regulator horizontal connection to where it would connect to the welder gas line is also too large as you can see from the connection on the regulator. Should I get a reducer for this or should I try get a single male - male connection to fit here?
OR really is this just too much effort and should I look for a different solution?