side-show-bob
Side-show-bob
- Messages
- 209
- Location
- West Yorkshire
Hi all i have a Clarke 150TE welder.
I am trying to weld patches on my T25 mostly around the wheel arches, and cannot get it to weld right. I can get a nice feed on setting 1 max with a wire feed of 4 but it is blowing holes in the thin metal. I have tried for the last hour to get a good feed on setting 1 min but all i am getting is splattering noise not the constant crackle you are looing for.
Can anyone tell me where i am going wrong??
Cheers
Rob
I am trying to weld patches on my T25 mostly around the wheel arches, and cannot get it to weld right. I can get a nice feed on setting 1 max with a wire feed of 4 but it is blowing holes in the thin metal. I have tried for the last hour to get a good feed on setting 1 min but all i am getting is splattering noise not the constant crackle you are looing for.
Can anyone tell me where i am going wrong??
Cheers
Rob