AndersK
Member
- Messages
- 1,490
- Location
- Sweden
Anyone have a good way to heat bend a 3mm acrylic sheet, 450 mm wide, 90° with a 50mm radius ?
Done a few attempts now around a pipe and it's just like bending a steel rod or similar without support. It first bends in a small rad leaving a gap before it follows the pipe.
Thought doing it slowly and with enough heat would do it but not.
Done a few attempts now around a pipe and it's just like bending a steel rod or similar without support. It first bends in a small rad leaving a gap before it follows the pipe.
Thought doing it slowly and with enough heat would do it but not.