Mark Davison
Member
- Messages
- 160
- Location
- London
As per title. Whilst getting ready to mill the very worn slideways on the underside of the table on my clarkson grinder I noticed it was reading low in the middle (clocking the newly scraped top face which i know is flat). I then moved the gauge finger to the mill's table top and noticed that was lower in the middle than at either end of its travel by about 0.05mm. Is that likely to be wear in the slideways on the underside of the table? I had noticed that it tightens up when wonder to each extreme so I guess thats the most likely explainaion?