Piero
Member
- Messages
- 1,396
- Location
- Uk
Hi Guys
I am trying to machine a channel along both edges of a precision tool makers vice I own.
A am trying to create a holding Grove along both edges to clamp the vice to my mill
It only has cutouts at each end length wise
I stupidly started with a carbide end mill am got about 3mm deep before the cutter was shoot
Yeah, stupid to try, I know
But I've started to I want to Finnish
I do not own a surface grinder but even then, it's probably not a surface grinder job
Is there any alternatives ????
I am trying to machine a channel along both edges of a precision tool makers vice I own.
A am trying to create a holding Grove along both edges to clamp the vice to my mill
It only has cutouts at each end length wise
I stupidly started with a carbide end mill am got about 3mm deep before the cutter was shoot
Yeah, stupid to try, I know
But I've started to I want to Finnish
I do not own a surface grinder but even then, it's probably not a surface grinder job
Is there any alternatives ????