Half round bar

[Spark plug]

Does anybody know ware I can get 50 x 25mm half round bar I only need about 1 meter tried a google but no success for a short length.

 

[Welderpaul]

Don't think i've ever seen it. You can get convex bar - square edge and feather edge, but not seen half round.

 

[oilcooled :)]

milling machine job of round bar i would say, wouldnt be common enough to be produced in lengths

 

[Spark plug]

The pieces I need are only 25 and 50mm long but I nee quite a few, I done a trial cutting it in half with the angle grinder but this wasn't ideal and that was a 25mm pice.

I could mill it but wasting a lot of material, it's probably the quickest way to do it.

 

[rikrobson]

Anyony you know got a evolution rage/fury table saw?
These are meant to cut steel.
with the guide at 25mm from the blade it should in theory be a simple job to run the bar over the saw

 

[Windy Miller]

Sounds like a job for a forge and a swage block

 

[astro_al]

Yup, get some forged up. Al

 

[hotrodder]

50 x 25 half round exists in stainless, for example... http://www.completestainless.ltd.uk/page/square_hex_and_half_round_bar buying short lengths will obviously be harder
Edit, and in mild steel... http://www.fhbrundle.co.uk/products/051210103__MILD_STEEL_HALF_ROUND_50X25MM_3M_HANDRAIL