Steve Morgan
New Member
- Messages
- 7
- Location
- Shropshire, UK
So I've just had my first MIG practice session with my R-Tech Mig180. For better or worse, here are the results. It's 3mm plate (overlapped), as I've not got anything thinner at the moment.
It seemed to go OK, but I'm not sure what's good and what's bad. It was obvious when penetration was too great, but I'm not sure if I got enough penetration on many of them.
Your advice or general critique would be most welcome.
View media item 9942View media item 9941
It seemed to go OK, but I'm not sure what's good and what's bad. It was obvious when penetration was too great, but I'm not sure if I got enough penetration on many of them.
Your advice or general critique would be most welcome.
View media item 9942View media item 9941