pressbrake1
Forum Supporter
- Messages
- 5,284
Visited him today and decided to share with you some pipe benders he’s made out of junk
One is a powered hilmour with a bit of car the other is a rotary draw type which he also made the dies for
the stuff is the pipe benderCan’t see what I’m supposed to be looking at there’s so much other stuff strewn about
Last picture. The piston is visible. As is the die and the block that retains the end of the pipe. Should be logical from that pointCan’t see what I’m supposed to be looking at there’s so much other stuff strewn about
Last picture. The piston is visible. As is the die and the block that retains the end of the pipe. Should be logical from that point
Oh well. Guess I’m not a logical person then
Yes. Saw that. Looks like it was cut to change the angle?I spotted that - I also spotted a big split in the bracket - or is that part not critical?
don't you mean crap say it how it isCan’t see what I’m supposed to be looking at there’s so much other stuff strewn about
don't you mean crap say it how it is
I ll shut the shop down for the day , buy some tube dig them out and make a video. Do I invoice you the £50 ph +vat im loosing and it would be helpful if you phone the let down customer and smooth it overPerhaps a video of it working would be better than these pictures. I do not see the purpose of the rear fog light and purple cable.
I ll shut the shop down for the day , buy some tube dig them out and make a video. Do I invoice you the £50 ph +vat im loosing and it would be helpful if you phone the let down customer and smooth it over
I didn't make it , I saw it it in someone else's shop as stated in post and the beauty of it is that its made from junkyard rubbishI had thought the reason why you started this thread is because you wanted to share the pipe bender you had made.