God mode restorations
Member
- Messages
- 8,101
- Location
- uk colchester
Hi everyone .
Been doing some reading about gears and how there measured. I was trying to find the dp of my shaper gear.
Now from what I can understand the calculations go like this.
Gear tooth count =36.
OD =100.
Add two to tooth count and divided by OD.
38 divided by 100 = 38dp.
Been doing some reading about gears and how there measured. I was trying to find the dp of my shaper gear.
Now from what I can understand the calculations go like this.
Gear tooth count =36.
OD =100.
Add two to tooth count and divided by OD.
38 divided by 100 = 38dp.