Xaver2Franz
New Member
- Messages
- 2
- Location
- Germany
I have a Fronius Transtig 1700 and wanted to work with a TR51MC spot device.
But when connecting there is no difference to see.
So I measured the tension between Pin A (Gnd) and Pin B (10V) at the rear 9 Pin connector.
There I get only 5V.
Does anybody has the same problem or can anybody confirm that there should be 10V.
If this is the case then I assume the transformer on the print (TMS 18) is broken and needs to be replaced.
I would appreciate to get some hints to solve the problem to activate the spot function for the Transtig 1700.
Cheers,
Xaver
But when connecting there is no difference to see.
So I measured the tension between Pin A (Gnd) and Pin B (10V) at the rear 9 Pin connector.
There I get only 5V.
Does anybody has the same problem or can anybody confirm that there should be 10V.
If this is the case then I assume the transformer on the print (TMS 18) is broken and needs to be replaced.
I would appreciate to get some hints to solve the problem to activate the spot function for the Transtig 1700.
Cheers,
Xaver
