Paul.
Moderator
- Messages
- 7,052
- Location
- Northampton. UK
A job I've been doing this week needs a deep 180 deg return with a 32mm radius on the edge of a 2mm aluminium sheet, there is at least 150 off them to do so its worth making a bit of simple tooling up to do the job,
Just clamped to a bench and an angle clamped at the other end as a stop, dead simple and very quick.
And this is how easy it is to use,
Just clamped to a bench and an angle clamped at the other end as a stop, dead simple and very quick.
And this is how easy it is to use,
Last edited: