JOEPRO
Member
- Messages
- 2,471
- Location
- UK
Pic says it all
This was a result of pumping it up to 11 with the duck bill lodged in a subframe.
SIP have sent me a new one no questions asked so this is now spare.
I am thinking instead of just junking it I might arc weld the casting back together.
Do I need to preheat it much bearing in mind there are seals inside? I will grind out a V and arc weld using rods like these:
This was a result of pumping it up to 11 with the duck bill lodged in a subframe.
SIP have sent me a new one no questions asked so this is now spare.
I am thinking instead of just junking it I might arc weld the casting back together.
Do I need to preheat it much bearing in mind there are seals inside? I will grind out a V and arc weld using rods like these: