chunkolini
celebrity artiste
- Messages
- 9,298
- Location
- Swansea
Not much metal bothering going on here at the moment so it's finish off the kitchen time.
I have to fit two worktops, each has a 90 degree joint near one end.
I will be cutting them outside with no proper workbench to clamp them down to; so circular saw is out of the question as I have a finite number of fingers.
I reckon get a nice new hand saw with small sharp teeth and cut them by hand, easuring the mitres first. I imagine a jigsaw making a horrible mess.
The other half is telling me to butt joint them at 90 degrees, but the edges are radiused and this will to me leave an ugly joint.
Sny tips for this potentially scary job.
I promise to be metal mangling again soon
I have to fit two worktops, each has a 90 degree joint near one end.
I will be cutting them outside with no proper workbench to clamp them down to; so circular saw is out of the question as I have a finite number of fingers.
I reckon get a nice new hand saw with small sharp teeth and cut them by hand, easuring the mitres first. I imagine a jigsaw making a horrible mess.
The other half is telling me to butt joint them at 90 degrees, but the edges are radiused and this will to me leave an ugly joint.
Sny tips for this potentially scary job.
I promise to be metal mangling again soon