Fitting help please

[Turbogn]

I have a lincoln 125 and I am having trouble finding a fitting for my welder. I need a 90 degree fitting which screws in to the back of the welder then in to the hose which goes to the regulator. Bacisally I need the hose in the back to 90 not come out straight. I am having trouble finding the parts to make this happen. Thank You for the help.
sal

 

[shenion]

You will probably need to make one up. Male-male right angle are common. Female connectors are rare as the fitting is supposed to be for flanged pipe.

My gas supplier has the female fittings.

Note: it might be easier to unscrew the fitting from the solenoid and put an extension and right angle on that. The input of the solenoid will have standard 1/4 or 1/8 NPT (pipe) threads.

That is how I did the same on my feeder, remove the 1/8" NPT to 5/8-18 adapter on the solenoid, use a short 1/8" pipe then a female/female right angle pipe fitting. I could have reinstalled the adapter, but whole purpose was to put a flowmeter there, then the adapter on it:


Above is the setup, the right angle adpater was needed as the flowmeter is right angle. I did swap the adapter for a male fitting as my hose was already female.