Going to have a go at some aluminium welding this afternoon. I don't have a foot pedal with my Sherman 206p. I will be welding two ends on a folded box from 2mm sheet. I know about degreasing and wire brushing with a as brush. Should I use my new gas lens kit.Can anyone give mesme pointers?
I'm thinking
100hz
80 amps
7lpm argon
1 sec pre flow
7 sec post flow
2 secs slope up @40amps
5 secs slope down @40 amps.
This is based in a little research and wild guessing!
Any thoughts?
Thanks, Paul.
I'm thinking
100hz
80 amps
7lpm argon
1 sec pre flow
7 sec post flow
2 secs slope up @40amps
5 secs slope down @40 amps.
This is based in a little research and wild guessing!
Any thoughts?
Thanks, Paul.