I've just finished fabricating a stand for my amplifier. With my new Clarke 151 (Thanks Weldequip ).
I followed the tutorial on this site, did a few practice runs and then went for it! Here's one of the welds. I'd really appreciate any feedback.
I presume it would have been better if I had done one continuous weld, rather than stopping at the corners.
Gas was CO2, 0.8mm wire.
I followed the tutorial on this site, did a few practice runs and then went for it! Here's one of the welds. I'd really appreciate any feedback.
I presume it would have been better if I had done one continuous weld, rather than stopping at the corners.
Gas was CO2, 0.8mm wire.