Few hours on my cold cut saw

[roofman]

Not the original stand for the saw but it fits pretty ok, held on by 2 clamps i have made either side...stand is bolted to a bit of 10mm plate with castors for moving about. Just waiting on a 4 pole flange motor now in 240V single phase (it was 3 phase), then i have to make some kind of coolant system up...Tomorrow the front wheel bearings on my 05 Renault trafic, should be fun anyway few pics of my saw.

 

[tom2207]

looks very smart

 

[ukracer]

Never mind the saw..look at all that space..lol

Where's the blade?

 

[roofman]

Never mind the saw..look at all that space..lol

Where's the blade?

never mind the space, wheres the wife with my cuppa and hob nobs

 

[tom2207]

never mind the space, wheres the wife with my cuppa and hob nobs

sounds like a dodgy euphemism to me ,,,

 

[scottmk1]

Did you get the Kawasaki green paint from @Pete. ?

 

[roofman]

Did you get the Kawasaki green paint from @Pete. ?

I never painted it, not painting the lower have either as i like the "hard life" look keeps the thieves temptation dampened down.

 

[mtt.tr]

I'm ashamed to show the state of the one I acquired.

Looking smart sir

 

[Memmeddu]

I was broken
I've got the occasion to buy one not once , but twice
Both dual voltage ,both water cooled.
One of those was was a stayer ,the other one I was really afraid to have no money to buy it , was a Pedrazzoli SUPER BROWN
The price was the same 100 euros
A real steal

 

[striker]

Looks neat. It doesn't look like you need the space, but I'd cut a door in the stand with a cutting disc. It would make a great little cabinet!

 

[8ob]

Just waiting on a 4 pole flange motor now in 240V single phase (it was 3 phase), then i have to make some kind of coolant system up..

Some of these cold saws run a pump off the end of the motor, the one I have has what looks like a lift pump running off a cam pushed onto the shaft, it would need to be the double shaft type motor.

1,549 × 1,037

 

[roofman]

Some of these cold saws run a pump off the end of the motor, the one I have has what looks like a lift pump running off a cam pushed onto the shaft, it would need to be the double shaft type motor.

1,549 × 1,037

I am after a flange fitting with a B5 frame..14mm keyed shaft Bob if you have one kicking about