Hi, I am pretty new to spraying but was pleased with the result after spraying etch primer onto the fuel tank of my car. That was until I noticed that I had not used the special thinners that were needed to activate the etching. I guess I am going to have to strip it all off and start again.
Graham
- Is that so? Would it help to spray the tank with the proper thinners for example?
- If it is so, what is the best way to remove the dud primer? The tank is on display at the rear of the car and I did a lot of work to fill dinks, rust pitting etc, so I am hoping for a non-damaging method.
Graham