Dress the edge over, or not?

[GraemeVW]

Well it's too late now, just hammered a couple of inch over. Gives a nice curve to the edge. Looks far more finished.
Too late to make that much noise though so I'll do it tomorrow. Committed now though!

 

[Erie Fred]

Well it's too late now, just hammered a couple of inch over. Gives a nice curve to the edge. Looks far more finished.
Too late to make that much noise though so I'll do it tomorrow. Committed now though!

Pix ?

 

[GraemeVW]

It's just made the corner look far less harsh. Still a small gap, which I expected, and which doesn't bother me. Just didn't like how square the edge was looking before.

 

[waddycall]

I take it back

 

[GraemeVW]

I take it back

I wasn't sure how it would go either.
I've done a fair bit of panel beating, I'm not too bad at it. But I don't normally shape 2mm steel!

It's been sanded, primed, and got the first top coat on. It's looking good. Didn't even bother seal sealing the little gap.
I'll put pick up once the second top coat is on.