Exuptoy
Member
- Messages
- 2,879
- Location
- Maesteg, South Wales
Guys, I have the typical Chinese/Eastern European swage but don’t think the standard dies go down as far as the internal 35mm dimensions of a 38mm mild steel pipe.
I don’t suppose anyone has a pair I could borrow before I start trying to knock up a set on the lathe?
I have one similar to this, although I’ve not measured the dies yet.
I don’t suppose anyone has a pair I could borrow before I start trying to knock up a set on the lathe?
I have one similar to this, although I’ve not measured the dies yet.