Shug
Member
- Messages
- 269
Finally got some gas and wire to replace the gasless wire I was using this weekend.
Using Air products coogar. Same as argoshield pretty much I think.
I was wondering about gas flow ( i used about 8/9 lpm ish) and was getting quite a lot of spattering. Switched to .6 wire and it seemed a lot better but still spattering. Tried different gas flow etc and not much difference.
Been wondering where I was going wrong. Maybe metal wasn't shiny enough, or something.
Just hit me that I forgot to switch the polarity after using gasless.
Now I just feel stupid.
At least I didn't blow up the welder.
Using Air products coogar. Same as argoshield pretty much I think.
I was wondering about gas flow ( i used about 8/9 lpm ish) and was getting quite a lot of spattering. Switched to .6 wire and it seemed a lot better but still spattering. Tried different gas flow etc and not much difference.
Been wondering where I was going wrong. Maybe metal wasn't shiny enough, or something.
Just hit me that I forgot to switch the polarity after using gasless.
Now I just feel stupid.
At least I didn't blow up the welder.