- Messages
- 13,280
- Location
- England
Did a bit more on my little Stuart 10V today.
One of the next bits i want to do is drill the cylinder, cylinder base and cylinder head.
Effectively 5 holed flange, on a 28odd pcd...
Ideally, i'd have a little rotary table, or a mill with DRO, but lacking either of them.
I have the Myford and drill press, and have a diving head in its box(never been use, and dont know how)
Any bright ideas on how I could drill accurately? I could use the base and cap to spot through to drill the cylinder. The usual 2mm clearance on bolt holes wont quite cut the mustard on this job
Could I somehow use the dividing head bolted on the drill bed? (table tilts/rotates etc)
I did look at some of the budget rotary tables, but not convinced myself to buy one just for this.
One of the next bits i want to do is drill the cylinder, cylinder base and cylinder head.
Effectively 5 holed flange, on a 28odd pcd...
Ideally, i'd have a little rotary table, or a mill with DRO, but lacking either of them.
I have the Myford and drill press, and have a diving head in its box(never been use, and dont know how)
Any bright ideas on how I could drill accurately? I could use the base and cap to spot through to drill the cylinder. The usual 2mm clearance on bolt holes wont quite cut the mustard on this job
Could I somehow use the dividing head bolted on the drill bed? (table tilts/rotates etc)
I did look at some of the budget rotary tables, but not convinced myself to buy one just for this.