- Messages
- 17,016
One of the rear ACE pipes on our Disco has developed a leak at the valve block end so I want to convert it to standard hydraulic fittings.
I've bought a used block so will need to get it drilled and tapped but need to get some hoses made up.
Basically I need to have a 3/8 BSP male fitting one end, a short length of hose and a 10mm compression fitting on the other.
Like this.
Anyone on here who can make up hoses? Would always be happier putting money in a forum members pocket than in a till.
@indy4x , you did the conversion on yours so may be able to point me in the right direction?
I've bought a used block so will need to get it drilled and tapped but need to get some hoses made up.
Basically I need to have a 3/8 BSP male fitting one end, a short length of hose and a 10mm compression fitting on the other.
Like this.
Anyone on here who can make up hoses? Would always be happier putting money in a forum members pocket than in a till.
@indy4x , you did the conversion on yours so may be able to point me in the right direction?