Dilemma

[jo1010]

At present I have the voltage set to maximum. My next move is to do a selection of different settings on current and voltage and see what improvement I can make.
Allan

Ok.
1). Set the wirespeed first according to your material (I'd suggest voltage set midway initially, then vary the voltage up and down and see the effect on the weld.
2) If that fails change the wire speed up and down one increment at a time and repeat step 1 above.

 

[AllanF]

Thank you for your help. Unfortunately, on my machine a Hitbox DP250, the wire feed setting is automatic.
Allan

 

[jo1010]

Thank you for your help. Unfortunately, on my machine a Hitbox DP250, the wire feed setting is automatic.
Allan

That's fine. The wire feed is set by your selection on "current"

 

[tom2207]

Thank you for your help. Unfortunately, on my machine a Hitbox DP250, the wire feed setting is automatic.
Allan

there will be a trim for it somewhere

 

[jo1010]

there will be a trim for it somewhere

As I understand it the voltage knob is the trim....