rcx132
Philip
- Messages
- 2,709
- Location
- London, UK
My buggy build just has the barebones electics at the moment, to wire the ECU and Check Engine , Oil, and Charge lights. There's a few generic sensors dotted around it, like a fuel level sender, fuel rail pressure sensor, that haven't been wired yet. They're not matched to any guage, so I was thinking of using an Arduino to translate the signal to something a guage can read. I'm thinking I'll have to find some simple guages and print custom backings for them.
Has anyone done something like this or has a different approach?
Has anyone done something like this or has a different approach?