Cv joint clips

[Mikey D]

Does anyone know of a good source for crimp on cv joint clips ? The one in question says B-73 on it and I'm guessing and roughly measures 73mm and needs to be about 9 mm wide.
The boot is ok and was replaced by myself about 6 months ago but the clip slipped off . The boot is one of the "plasticky " sort and pretty rigid so a cable tie won't cut the mustard !
Cheers mike

 

[Ruffian]

Any decent factor will do them,
Usually use the shaftec ones but with the plastic ones either a bit of jb weld or superglue to help bond it to the cv cup.

 

[doubleboost]

I use thin stainless hose clips they are the only thing that will hold on the plastic boots

 

[Mikey D]

Thanks for the replies gents , I am inclined to go with the stainless hose clip suggestion , access isnt t too good to get ade ent. Crimp anyway without taking the driveshaft out

 

[Bill Edwards]

Decent motor factors will sell you the proper thing which work. Cheap ones shouldn't be touched, and you need a decent tool to give it a proper crimp.