Theblackbox
Member
- Messages
- 342
- Location
- Somerset uk
Hi all. Quite a large portion of my work now is making dog cages for cars and vans. I use 38x38mmx3mm weld mesh. Usually go through around 15 sheets a month so a fair amount of cutting!
Currently I’m marking and cutting it with a thin cutting disk it’s quick but does generate dust and uses up disks quite quickly.
I wondered if there was a corded/cordless shear type tool that anyone can recommend to cut through this quickly to reduce the dust etc.
I’m only cutting where it’s a single strand so will need to cut through 3mm wire.
Standard bolt croppers are too slow for this work.
Thanks all
Currently I’m marking and cutting it with a thin cutting disk it’s quick but does generate dust and uses up disks quite quickly.
I wondered if there was a corded/cordless shear type tool that anyone can recommend to cut through this quickly to reduce the dust etc.
I’m only cutting where it’s a single strand so will need to cut through 3mm wire.
Standard bolt croppers are too slow for this work.
Thanks all