123hotchef
Member
- Messages
- 13,989
- Location
- Kent
I'd drill a couple of holes for the internal rads along with the other holes and as said above get jiggy with it or clamp in some moles and hand fettle with the 115mm grinderette. Finish off with a chalk loaded file for those perfect edges.
Tbh I'd have re-done in st/st. Old commercial door kick plates are a useful source if you can grab them.
Stainless.
I did think about using stainless but it is harder to work with
But it doesn't go all white and powdery and look naff!