Hi
I was hoping for a little advice please. My van needs a few bits and pieces needing doing but most of them are fairly flat so I've confident enough with them.
When it comes to the rear quarter it looks a bit more tricky shape due to the crease.
Can I get some advice on the best way to tackle this please?
My initial thought was to get that section cut out of a breaker - quite a bit larger than needed then get it welded in, grind it back, epoxy primer, fill, epoxy then move to paint stages.
Thanks
I was hoping for a little advice please. My van needs a few bits and pieces needing doing but most of them are fairly flat so I've confident enough with them.
When it comes to the rear quarter it looks a bit more tricky shape due to the crease.
Can I get some advice on the best way to tackle this please?
My initial thought was to get that section cut out of a breaker - quite a bit larger than needed then get it welded in, grind it back, epoxy primer, fill, epoxy then move to paint stages.
Thanks