Phil Jelley
New Member
- Messages
- 1
- Location
- Wirral, UK
Hi All,
I'm a newbie to welding so please bear with me.
I was given a Cosmo 150 welder with a new euro torch and conversion kit that needed fitting.
I have fitted the actual connector to the welder and set the wire feed up but at this point i'm come to a halt around the wiring. Unfortunately i cannot read wiring diagrams as i've been through a lot of posts already only with these. The connector has the hose for the gas (i've worked this bit out lol), but it also has 2 black wires but i don't know where these go, also there are cables that connect onto where the wire feeds through. Again lost what i do here.
I also have worked out from reading these forums that i need to fit a gas solenoid.
So does anyone have a noddy guide with pics that i could follow, if so i'd be much apreciated, or if anyone can describe what i need to do in proper noddy language that would be great.
Thanks in advance.
Phil
I'm a newbie to welding so please bear with me.
I was given a Cosmo 150 welder with a new euro torch and conversion kit that needed fitting.
I have fitted the actual connector to the welder and set the wire feed up but at this point i'm come to a halt around the wiring. Unfortunately i cannot read wiring diagrams as i've been through a lot of posts already only with these. The connector has the hose for the gas (i've worked this bit out lol), but it also has 2 black wires but i don't know where these go, also there are cables that connect onto where the wire feeds through. Again lost what i do here.
I also have worked out from reading these forums that i need to fit a gas solenoid.
So does anyone have a noddy guide with pics that i could follow, if so i'd be much apreciated, or if anyone can describe what i need to do in proper noddy language that would be great.
Thanks in advance.
Phil
