Converting a press to bend metal

[DrNik]

I've got a 20 ton bearing press and want to bend plate, 6mm will probably be the thickest, so I need you guys to draw me a good design I can copy, it needs to be accurate, and although a knife and a piece of angle iron will give me 90 degrees, it would be nice to have it so the more I pump the greater the angle, right get those creative juices going

 

[Fazerruss]

I think the term you mean is called air bending (but I could be wrong). The bottom press die has a very deep v . This method is normally used for thin sheet though.
Do a search for my previous threads as I converted my press for bending.

 

[DrNik]

Ok will do